How To Secure Leaning Mirror On Mantle

Have you ever seen leaning mirror on mantle? Yes, it is an interesting decoration and this decoration usually found on mantel. This leaning mirror on mantle adds beauty and elegance to your home.

However, it can be risky to place the leaning mirror on mantle. So, here some tips about leaning mirror on mantle. And, how do you secure leaning mirror on mantle? Continue reading this post to get the answer.

Let’s start now.

How to Secure The Leaning Mirror on a Mantle

Place A Leaning Mirror On A Mantle

It is critical to install a leaning mirror on the mantle.

Do not try to freestyle this if you do not have experience.

You should always arrange the mirror in a 45-degree angle. This will maintain the stability of the leaning mirror. You can place the mirror horizontally or vertically.

It depends on your taste. However, it is better if you arrange it horizontally.

To do this, take the leaning mirror (from top to bottom), measure 4 inches from the center, and mark.

Then, measure another 4 inches, and repeat the same procedure. Measure another 4 inches, and repeat the same procedure. You should have four equal marks.

Then, take the long side of the mirror, and position it against the long side of the mantle.

This will allow you to view everything as 90 degrees. Therefore, you can position the mirror. Next, hang the leaning mirror on the mantle. It should lean back, and this will be perfect.

When installing the leaning mirror on the mantle, you should pay attention to the method of securing the mirror. This is essential, and you can lean the mirror until it looks attractive.

Mark A Anchor Point For The Leaning Mirror

The purpose at this step is to mark the anchor point.

It is the point at which the leaning mirror is connected to the top mantle.

Keep in mind that if you do not have a mantel, you can place a piece of wood.

It’s an effect that gives the impression o f a mantel.

However, you will utilize an anchor point o f wood for this purpose.

Mark the location where the top of the leaning mirror will connect.

Make a Hole in the Wall

When you’ve marked everything, t hen you can begin to make a hole in the wall.

It is now time to drill a hole.

You will do so by drilling 1/4 inch diameter holes at each mark you’ve made.

This is analogous to hoeing holes in the floor.

To finish the operation, you’ll have to drill pilot holes.

Drilling must be done accurately.

To Secure the Mirror, Use a Metal or Plastic Anchor.

The last step is to secure the mirror on the wall.

When done correctly, the leaning mirror will not turn over.

It will also not go forward after one year.

To do this, you have to use an anchor. There are many types of anchors on the market.

You can use plastic anchors, or metal anchors. However, always choose anchors that suit your wall.

If you’re still concerned about it, you can use more than one anchor.

This will guarantee that it has increased steadiness.

If you only have one anchor, try to use it in a corner. That corner will provide more support.

You can also secure the mirror with a nail. However, this will only be a temporary solution.

Also Read: How To Arrange Circle Mirrors On Wall

Final Words

These are the most important methods to secure any form of mirror to the wall.

To hang a leaning mirror (also known as tilting mirrors), you should place the mirror on a stand.

Mark the place where the wall is, and drill some holes.

Drill a hole at that spot, then hook the mirror to the stand.

Remember, the goal is to keep any form of mirror steady, so it doesn’t matter which method you use.

The anchor will guarantee that this is the one thing you try.

It may take some time to set, but it will also last for a long time.

It all boils down to getting the things right, which is fundamental to successful DIY projects.